Thermo-Flex
Plus
is a heat transfer material suitable for most cotton,
cotton-polyester, wool, lycra, and other basic fabrics including many
athletic mesh fabrics. The self adhesive layer permits high speed
cutting, ultra-fine detail, and easy weeding. Cut in mirror image
through adhesive layer (dull side) to the plastic backing. Weed the
excess material and lay the cut pattern on the fabric. Cover the design
area with paper or cloth release sheet. Irons can be used, but for best
results, a heat press is preferred at 340º-350ºF
for 20 seconds. When transfer is cool to the touch, peel away backing
sheet. Transferred image may be covered with a non-stick sheet and
re-heated if necessary. you should use firm or hard pressure for proper
transfer.
|
