(800) 967-3929


Setting up the Roland GX-24 for Axis Swap

By default, the new Roland GX-24 plotter is setup for cutting from left to right, rather than cutting tdown the length of the roll. Most sign specific software, such as SignLab, FlexiSign, and ProDeSIGN expects the orientation to run the length of the roll. Roland calls this Rotate 0 or Rotate 90. To change the default, follow these instructions:

Load material in the machine.(the display will say SETUP SHEET, and ROLL
P
ress ENTER
(Note that the cutting head will stop on the left hand side of the machine.)
Press MENU button twice
Press DOWN ARROW once (the top of the display says CONDITION)
Press the RIGHT ARROW once (the top of the display says FORCE)
Press the UP ARROW twice (the top of the display says ROTATE)
Press the RIGHT ARROW once (the bottom of the display says 0 deg)
Press the DOWN ARROW once (the bottom of the display says 90 deg)
Press ENTER
Press the MENU button twice (the top of the display says UNSETUP)
Press ENTER (the display says SELECT SHEET >ROLL)
Press ENTER

(Note that the head will now scan the size of the vinyl and stop on the right side of the material.)

THAT'S IT!

 

 

 

 

Click here to e-mail us with questions or suggestions for future articles.

Send To Printer


Home Plotters Printers Used Equipment Engravers Software Vinyl Film Application Tape Internet Specials
Plotter Supplies
Printing Supplies Only@Ordway's Exclusives Vinyl Lettering Services Digital Printing Services
Complete Catalog Financial Services FAQ's / Tech Support Directions to our Store About Us Secure Order Form
Heat Transfer Materials Roland InkJet Media and Ink ColorCamm Supplies


Ordway Sign Supply, Inc.   16201 Vanowen St.   Van Nuys, CA 91406
(818) 908-9666  Fax (818) 908-9673
e-mail us -
click here